
Oster® Cryogen-X™ blades are Manufactured from fine-grain,
high-carbon steel that is cryogenically treated so edges stay sharper longer. American-made blades
have a Rockwell Hardness rating of 62 and stay ultra cool during operation for
optimum durability.
*PRICES ARE PER BLADE-You pick blade or blades you would like from drop down menu (Prices may vary)
*Large numbers on
blades make identification easier.
*USA-made blades
*Rockwell Hardness rating of 62
*Stay ultra cool during operation for optimum durability
BLADE USES (also see chart below):
The Oster Cryogen-X Size 5/8 blade leaves
hair 1/32". Used to work in tight areas and cutting about the same length
of the Size 30 Blade, this blade is useful for poodle patterns and clipping
around feet. The blade is also great for the inside of some smaller ears.
The Oster Cryogen-X Size 7/8 blade leaves
hair 1/32". Used to work in tight areas and cutting about the same length
as the Size 30 Blade, this blade is useful for poodle patterns and clipping
around feet. The blade is also great for the inside of some smaller ears.
The Oster Cryogen-X Size 3 blade leaves
1/2" and is great for stand up type coats like heavy coated poodles and
bichons. It leaves the coat at a length that resembles hand scissoring without
all the work. Great for pet owners wanting nice length over all.
The Oster Cryogen-X Size 4F blade leaves
3/8" and is great for drop coat breeds. Breeds such as Spaniels, most
Terriers, Maltese with coats that lay flat to the skin will benefit from this
blade. The coat is combed down as you clipper, leaving it smooth and line free.
The Oster Cryogen-X Size 4 Skiptooth blade
leaves 3/8" and is great for fluffy type coats such as Poodles and
Bichons. It does not comb the hair flat to the body when cutting, as the full
tooth blade does. Great for body clipping as well as one length, all over
trims.
The Oster Cryogen-X Size 5F blade leaves
1/4". With the Size 5F blade a short, smooth finished can be achieved.
Great on certain sporting and terrier breeds that have a back coat which lays
flat to the skin.
The Oster Cryogen-X Size 5 Skiptooth blade
leaves 1/4" and is used on fluffy type coats such as poodles, bichons and
dogs with similar type coats. The Size 5 skiptooth blade leaves the coat
standing rather than combing it down for a better, faster finish.
The Oster Cryogen-X Size 7F blade leaves
1/8" and is often used to shave down very matted dogs and cats. This blade
also gives a short, clean finish if desired on some sporting and terrier
breeds. Blade can be used against the lay of the coat for lion trims or to
remove hair from cats.
The Oster Cryogen-X Size 7 Skiptooth blade
leaves 1/8". The shortest of the skip tooth blades, the Size 7 is for use
on very matted dog coats. The Size 7 Skip Tooth blade cuts through mats that
other length blades cannot penetrate. The coat is more accessible to the
cutting blade because of the flat design of this blade. The teeth are more open
which allows the coat to be cut easier than the 7F blade with its full teeth.
The Oster Cryogen-X Size 8 1/2 blade
leaves 7/64". This blade is a good choice when a Size 10 blade is too
close for sensitive skin. Caution: The cutting blade is more exposed than the
Size 10 due to the wide spaces of the comb of the blade. This means that it may
cut the dog easier than the Size 10 blade.
The Oster Cryogen-X Size 9 blade leaves
hair 7/64". This blade is a shorter than the Size 8 1/2 but longer than
the Size 10 Blade. It can be used for close clipper work on some poodles,
spaniels and terrier with sensitive skin. Remember that the cutting blade is
more expose which means it is possible to cut the dog easier than with the Size
10.
The Oster Cryogen-X Size 10 blade leaves
hair 1/16". This size blade comes standard with many new clippers. The
Size 10 Blade is great for sanitary trimming (bellies, around eyes, rectum and
pads of feet) of any breed. For most close clipper work on poodles, spaniels
and terriers, the Size 10 Blade is the blade of choice. Leaving a clean finish,
the Size 10 Blade is safe for use on dogs and cats that are too matted for
other blades to cut under and remove mats.
The Oster Cryogen-X Size 10 Wide blade
leaves hair 3/32" and is similar to the regular Size 10 Blade but has a
wider cutting edge. The Size 10 Wide Blade is used for horses and shaving down
matted dogs.
The Oster Cryogen-X Size 15 blade leaves
hair 3/64". The Size 15 Blade is often used on Poodles for clipper work on
the face, feet and tail. The Size 15 Blade is ideal when the Size 10 Blade is
not smooth enough and a Size 30 Blade is too close. This blade can also be used
for sanitary prep.
The Oster Cryogen-X Size 30 blade leaves
hair 1/50". This blade is used on pet poodles with less sensitive skin or
show poodles with sensitive skin conditioned for its use.
The Oster Cryogen-X Size 40 blade leaves
hair 1/100". The Size 40 Blade should only be used by experienced
groomers. An ideal blade for show poodles. This blade is the blade of choice
among veterinarians for prepping pets off all types for surgery.
The Oster Cryogen-X Size 50 blade leaves
hair 1/125". Blade of choice for veterinarians prepping pets for surgery.
This blade should only be used by experienced groomers. Great for an extra
close finish on show poodles.
*BELOW IS SIMPLIFIED “BASIC” CHART WITH SUGGESTED USES
FOR EACH BLADE SIZE-Please note that these are only suggested uses.

NOTE regarding Skip
Tooth Blades - 3, 4, 5 or 7
Skip Tooth
Blades are generally used instead of a finish cut blade when:
Hair or coat is
heavily matted or for VERY thick coats.-The coarse or uneven teeth on a Skip
Tooth will feed the hair into the cutting blade more effectively, which allows
you to clip under mats.
Often used before the bath for rough-cuts, and on dogs that must be shaved
completely down. Perfect for blending short areas with longer lengths. Ideal
for coarse-coated breeds such as Terriers
A hair cut using a
skip tooth blade is generally "finished" off with the same size
finish blade to give coat a smooth, finished appearance...for example: if
you cut hair with a 4 skip-tooth blade, finish off with a 4F blade
Blades Are For use
with any types of clippers which accept full size, detachable (A5 style) type
blades including but not limited to: Oster® A5® Turbo, Golden, Powermax, Ultra
PowerPro and Powerpro, Outlaw, Volt, 76, etc.
Andis® AG®, AGC®, AGP,
AGR, BG, BGC, BGR, MBG, Powergroom, AGR+, BGR+, AGRC, AGRV, BGRV, Ceramic
Advanced™ Detachable Blade Clipper (Model:21490)
- Excel™ Detachable Blade Clipper (Model:22310)
- BGRC Detachable Blade Clipper (Model:63965)
- MGX Detachable Blade Clipper (Model:21495)
- Excel™ 2-Speed Detachable Blade Clipper (Model:22315)
- BGR + Rechargeable Detachable Blade Clipper (Model:64850), etc.
Laube® models:
503/513/505/553/555/573/Lightening/Micro
Moser models: KM1/Max 45/Alavon/Artiko
Thrive models: 900N/50 range
Wahl® models: Switchblade, Storm, KM1®, KM2®, etc
GEIB Models: Geib Zero Heat 2-Speed Clipper
CONAIR models: ConAir Canine FX Dyna-Groom II Professional 2-Speed
Clipper, ConAir Canine FX Turbo-Groom II Clipper 2-Speed, ConAir Canine FX
Lightweight Power Clipper, Conair Dyna-Groom 2 Speed Clipper
I sell all kinds of NEW, Top Quality Grooming products
and Pet Supplies from Oster, Andis, Laube, Wahl, Master Grooming Tools, Paw
Brothers, Coastal, Millers Forge, Resco, Top Performance, Geib, etc and all
kinds of Bandanas, Fitted Bandanas (Hav-a-danna, Amazing-Danna Doo rags or
Skull caps), USA MADE Flags and similar items and a whole lot more in my Ebay
Store...be sure to check it out!
Be sure to add me to your favorites list!
*International Buyers – Please Note:
Import duties, taxes, and charges are not included in
the item price or shipping cost. These charges are the buyer's responsibility.
Please check with your country's customs office to determine what these
additional costs will be prior to bidding or buying. Also, you may experience
delivery delays or experience longer shipping times due to customs-related
delays.
I am a USA
seller selling Products made for use in the USA & CANADA-unless otherwise
stated ALL items are set up for USA/Canada 110 volt and would need some type of
voltage transformer (generally available at any electronics store)to work
properly outside of USA/Canada.
Yes, I do combine shipping....all items must be paid
for on one invoice to qualify for discount…please wait for combined invoice
with discount before making payment on multi-item purchases....if in question
PLEASE Email me before making payment
I buy in large wholesale quantities / lots at a major
discount and pass on the savings to my customers.
Yes, I do also sell almost everything I sell in
WHOLESALE QUANTITIES at WHOLESALE PRICES...Email me for quote if interested!
If Any Questions Please Ask Before Buying or Bidding
Thank You for Looking!