We were unable to complete your request. Please try again later.
This part is not compatible with this
Compatibility information is not available for this item.
This part is compatible with below vehicle(s).
Compatibilities are defined by the seller for vehicles typically fitted for operation within the original listing country.This part is compatible with below vehicle(s) matching this.
Compatibilities are defined by the seller for vehicles typically fitted for operation within the original listing country.
This listing is for part or sub-assembly number given below only.
Interior diameter: 53 mm
Exterior diameter: 115 mm
Thickness: 14 mm
Number of wires : 7
Number of plugs: 3
Number of terminals : 7
Wire to wire resistance:
Alternator : White Between each White = 0.2 ohms+/-20%
Pickup : White to Red= 450 ohms+/-20%
Source : Green to Brown= 320ohms+/-20%
Before installing your new stator
Check the AC output of the stator.
Replace any burned or corroded connectors on stator and regulator/rectifier
Check and repair any melted wiring.
Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".