PLC Peripheral Modules

The stability of aquarium temperature is one of the crucial factors that contributes to the health and safety of your fish. Automatic over temperature alarm. Sensor: NTC sensor. Dual heating and cooling function.

Applications:Aquarium, Terrarium, Vivarium, Paludarium ,Chicken Incubator. The stability of aquarium temperature is one of the crucial factors that contributes to the health and safety of your fish. Automatic over temperature alarm.

Measuring accuracy: /-0.5%FSCold-end compensation tolerance: /-2 Celsius(can be modified by software in 0~50 Celsius)Resolution: 14 bitSampling cycle: 0.5 SecPower : AC 100-240V 50/60HZProcess value (PV), Setting value (SV)PIN control (including ON/OFF, step-type PID and continuous PID)Self-tuning controlRelay output: contact capacity 250V AC 3A (resistive load)Proportional band (P): 0~full range (ON/OFF control when set to 0)Detective temperature range: 0 to 400 CelsiusInsulation resistance: more than the 50M ohm(500V DC)Insulation resistance : 1500V AC/minInsulation resistance : Power Consumption Less than 10 VAService environment: 0~50 Celsiusenvironment with no corrosive gas 30~85% RHAluminum Alloy Heat SinkSpecification:Materail: Aluminium alloy.Size:.

Relay: 20A. Automatically start cooling or heating for constant temperature. Set highest/ lowest upper limit temp to avoid accident. Can select cooling or heating working mode. Temperature range: -55-120 ℃.

Rated current: 10A. Temperature sensor: NTC 25 Celsius degree=10K B3435. 1PC Temperature Sensor. Working temperature:‐20~70 Celsius degree. Item weight: 93g / 3oz. 125g / 4.4oz.

With zero clearing switch on the right side. Nice appearance and comfortable feel. Compact design and portable. Other country.

Refresh rate: 0.5S. LED: Shows LL is the sensor open, showing ?. HH is out of range, the thermostat will be forced to close the relay, the display --- as high temperature protection. Indicator: Off The relay is switched off, Always indicate the relay is closed.

Output:10 a relay all the way. 1 x Temperature Sensor. High temperature protection:0-110℃. Temperature 0.1℃,other paragraph 1℃. 1 x Instruction Manual. Size:48mm(length) x 29mm(width) x 32mm.

Refrigeration power: Qcmax 50-60 w. Size: 40mm x 40mm x 3.6mm. You may expect to receive a response to your inquiry within 24 hours.

Maximum output load: 2200w (220v); Alarm when over-temperature and sensor error. Alarm: High/ Low Limit setting Alarm. Relay Output: Cooling(10A,100-240VAC). Sensor Type: NTC Sensor(including). Temperature Resolution : 0.1 ℃ / 0.1℉.

Setting (start humidity): Press and hold △ key to start the humidity value flashing. Set the humidity value by △ ▽ key. Set [Stop Humidity]: Press and hold △ key to stop the humidity value flashing, and set the humidity to stop by △ ▽ key value.

Chip type: W5500. 1 x SPI to Ethernet/TCP/IP W5500 Module. Supports Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE. Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE.