PLC Processors

Use AMG8833 infrared thermal sensor. The resolution is 8x8! Note: Since the resolution is only 8x8! Detection temperature: 0~80 degrees.

14443A compatible transponder signals. RC522 Card Read Antenna RF Module RFID Reader IC Card Proximity Module. RC522 chip This module can be directly loaded into the various reader molds. 1 x RC522 Card Read Antenna RFID Reader IC Card Proximity Module.

Transistor output: 100K pulse, 1A high current, source type (PNP). 214-2AD23-0XB8 Transistor Type PLC DC 24V Input/DC 24V Output. DC24V, switch 14 input 10 output, analog 2 into 1 out, analog to digital conversion 3ms.

We will reply you in 24 hours and give your a satified answer.

· Perfect fit for XIZI. · Perfect fit for OTIS & XIZI OTIS. · Double line LCD display, key clear. We will try our best to reduce the risk of the custom duties. · Color: Blue.

(Note: do not support calls). Interface: 3.5mm headphone jack.

15438, fever decoder board, USB computer fever decoder board, OTG, fever DA, C external decoder, can be used to change the power amplifier USB input. At present, all the sounds of the computer are normal, even if the 32 bit 192K is normally played.

Dual Y axis interface, can drive 2A 4 phase 2 wire stepper motor. 1x USB 2 Axis Stepper Motor Driver Board. Fit for DIY desktop laser engraver,dispensing machines printer,plotter. Support Stepper Motor:Motor within 2A 2-phase 4-wire.

Arduino Module. Single H-Bridge output current:1.5A(It can drive two DC motor). Short circuit protection:YES. DC motor which drive current is less then 1.5A. ULT PIN:mode set.Low level is sleep mode. Raspberry Pi.

This is hardware version 0.4.3c speeduino bare printed circuit board plus hardware version 3 VR bare printed circuit board. Both boards have solder mask and. are screen printed as pictured. The speeduino board was designed by.

CS/CJ/CQM1H/CPM 2C etc.series PLC,with. USB interface adapter for. Compatible cable, not an original one. It is fast, Easy and Safe. Australia & Canada.

Supported card types: mifare1 S50, mifare1 S70, mifare UltraLight, mifare Pro, mifare Desfire. 1 Standard S50 card. 1 RFID-RC522 module. United States. Data transfer rate: Up to 10Mbit / s. Relative Humidity: 5% -95%.

200 300 400PLC compatible communication. system DP s7/MPI/PPI interface. After you place an order, we can help you to get the detailed information of your item. High quality ues top-rate chip and best quality Wire.

We will reply you ASAP. DO NOT send without communication.

We will reply you in 24 hours and give your a satified answer.

(1pcs x CN040. Good communication is the best way to solve any issues. We are not responsible for any item sent to us that is not our product.).

Special situations are examined on a case to case basis.

We will reply you ASAP. DO NOT send without communication.

Conditiion: New. Rate (item arrived).

For its crank and cam signals, Speeduino requires 3.3v-5v square wave pulses. Such signals can be inputted directly from hall or optical sensors, however the common Variable Reluctance (VR) sensor requires conditioning in order to convert its AC signal.

Taiwan DINKLE fireproof nylon material DIN rail mount carrier (not China low quality carrier), can support width 35mm / 32mm / 15mm rail, and the carrier can be taken apart for panel mount use.

100% NEW OMRON SERVO drive R7D-AP02H IN BOX. 1pcs R7D-AP02H (made in Japan). 100% quality warranty ! 100% NEW ! 3 year warranty !

Digital input module, Switch module 16CH isolated DI RS485 MODBUS communication Digital module(A4A2). 3, communication with input and status indicator. 1, Digital input channels 16 channels (active low).

We will reply you ASAP. DO NOT send without communication.

We will reply you ASAP. DO NOT send without communication.

Zelio Logic. To be used with Zelio Soft software. Connecting cable. For smart relay. To connect the relay to the PC. 9.84 ft (3 m). cable length. Windows XP.

Model: Fanuc OT - A98L-0001-0518#T. 1pcs Fanuc OT - A98L-0001-0518#T. Weight: 0.35kg.

Output can connect PLC 24V. Functuon: Test whether AC 220V is existed.

2, the materials are very sophisticated, using 2 high-performance LDO, the price is very expensive, do not hesitate to strengthen the power for the sound. 3, using ak4118 to receive, has the lowest Jitter in the industry.

(Old Version). Warranty&Reture Policy.

Supported card types: mifare1 S50, mifare1 S70, mifare UltraLight, mifare Pro, mifare Desfire. 1 RFID-RC522 module. Load: 250V 10A AC or 30V 10A DC. Current :13-26mA / DC 3.3V. Idle current :10-13mA / DC 3.3V.

We will reply you in 24 hours and give your a satified answer.

DO NOT send without communication.

We will reply to you ASAP.