 |
Like most of the parts on the TC201 line of soldering handles the EC234 (heater) lasts a long time. When my 30+ year old TC201 handle's heater finally gave up the ghost I built the TC201T version out of other not working TC201T parts that use the new plugin heater (EC234) knowing that it will probably last longer than I will. Yes you can buy a complete Chinese soldering iron cheaper than a complete Weller TC201T handle but will they work as well as a Weller for 30+ years?
Verified purchase: Yes | Condition: New
Original threaded sleeve would not fit, to tight. Outside diameter of heating element just barely to large. However a new replacement sleeve did fit.
Verified purchase: Yes | Condition: New
Unit was OK, the heater resistance measured fine at 12-13 ohms, however I needed the older version of it with the straight tube so my tip retainer shield would not slide over the wider outer half of the tube.
Verified purchase: Yes | Condition: New
renewed an older weller solder iron unit perfectly. you do have to buy the newer outer barrel to go with it, but overall much cheaper than a new unit.
Verified purchase: Yes | Condition: New
Wasn't sure if it would work in my Weller iron but it turned out perfectly.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Soldering Guns & Irons
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Soldering Guns & Irons
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
