Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Starters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Starters
Simply wire input to the top. black on left white on the right. Then wiring output to motor on the bottom with the same black on the left and white on the right. Then wire the pressure switch inline to the on/off switch on the bottom long wire. You can simply cut the blue wire going to the built in breaker from the on/off switch and splice the pressure switch inline. Very simple install.
Verified purchase: Yes | Condition: New
Works great on my 7.5hp single phase industrial compressor I converted from 10hp 3phase. This compressor is remotely mounted and not used everyday, so this not only took the stress off of my pressure switch but allowed me to turn the compressor off from another building without having long runs of expensive wire.
Verified purchase: Yes | Condition: New
Works as it should. I oversized it for my 5 hp motor to be sure it will hold up. Not the nicest unit I have seen. Mostly poor fit in box, but once you close the cover it looks great and works great. I'm unsure of the longevity of this unit as it has only functioned 50 times. I'm pleased with the unit for the price. Good value for the price. Don't expect a square D.
Verified purchase: Yes | Condition: New
Larger than I expected and solidly built. There is nothing I would change. Plenty of room for routing wires. I won't know durability for awhile but so far so good. This is controlling a 6 HP motor on a compressor so there's margin.
Verified purchase: Yes | Condition: New
starter held in enclosure with only 1 screw. small size made wiring difficult. load side lugs were lacking. ended up mounting starter in existing enclosure. i used 3 screws! compressor ran 2 cycles without incident.
Verified purchase: Yes | Condition: New