Works to seal for tubeless setup, however, it's very thin. Needed at least two wraps to work on a road tire PSI. May work better on a mountain setup, where PSI is much lower. Had split at a spoke hole with 110PSI with one wrap, two wraps has held fine.
Verified purchase: Yes | Condition: New
Nice tape, works well for road pressure also.. appears a little thinner than Stan's. Only complaint is that one of the roll's must have been dropped or bumped against something during packaging and caused a simple in tape. As a result the first 5 or 6 layers kept splitting apart as the tape came off the roll which wasted tape
Verified purchase: Yes | Condition: New
My first attempt at tubeless. This tape did the job. I used two wraps, but only one over the valve hole. Took time pushing out any little air bubbles. Tires held pressure as if there was a tube in there. And I have a supply to do ten more.
Verified purchase: Yes | Condition: New
Exactly the same as the light yellow tape, just blue! If you have drilled fatbike rims make sure that you get wide tape. learn from my mistake.
Verified purchase: Yes | Condition: New
This is my 3rd roll of this stuff- live it. Been using it in aluminum and carbon road, mountain and cross wheels. Here is the only catch- it’s a bit thin- thinner than Stan’s. Solution: just do two wraps. Simple. Great deal and good stuff.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Rims
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Rims