I had to modify parts of the radiator so the stock fan wouldn't make contact with it. Also, the two bolts on the bottom of the radiator was a little off center. I had to push the radiator about a quarter inch to the left so it would fit. The lower rubber radiator hose has a slight "S" shape to it now, but it still work. Lastly, the radiator cap doesn't fit/close correctly. kl
Verified purchase: Yes | Condition: New
The radiator bolted in, but the fan blade did not rotate 360 degrees because of the attached radiator can shrowd. Had to remove a portion of shows to make it work. Also the bolt hole on the side of the shroud were all off, and not where they were suppose to be. This part was supposed to be OEM parts.they are not!!!!!
Verified purchase: Yes | Condition: New
Good looking radiator for the price. The shroud is not the same as oem and did not allow for the fan clearance. I'm not sure my fan is oem. It is 4 blade and 18 inches. I will find a different fan to make it work. I am happy with the purchase .
Verified purchase: Yes | Condition: New
Fits great, machine runs much cooler now, will buy again if needed
Verified purchase: Yes | Condition: New
Box arrived damaged, upper hose connection pushed in. after installing we found out the inner metal housing was 1/4 inch larger then the original causing the fan to fit.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Antique & Vintage Equipment Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Antique & Vintage Equipment Parts