Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Splash Guards & Mud Flaps
Good product. The fit is just fine. Takes about 20 minutes a side. You have to drill 2, 1/8" holes, per side, through the bed pinch welds for the 2 inside screws. Zipped the screws right in. But, be prepared. There are NOT enough screws to do the install. You should buy 6 more screws before you begin the install. The instructions are OK. The install is pretty straight forward. The install does not interfere with the goose neck hitch.
Verified purchase: Yes | Condition: New
I got tired of hearing the rocks ping off the inside of the rear wheel wells so I bought these. What a difference! Installation took about 20 minutes total, couldn't have been much easier and all required parts were included with good instructions. Highly recommended!
Verified purchase: Yes | Condition: New
I cant believe how bad these fit my 2016 F250 ford standard cab. They could not be mounted flush fore and aft with fender without bowing in the middle. These steps became catchalls. Even after elongating holes and grinding the edges off fender washers they had a bow in the middle. This drips on leaf springs instead of down beside. Front tab did not line up with three existing holes in fender. Two half moon cutouts on outboard side were excessive and show in wheel well area no matter how you position. Both sides was about the same
Verified purchase: Yes | Condition: New
Very happy with this product. Put them on my new 2016 F350. I like them better then the factory ones. They are heavy duty and easy to install
Verified purchase: Yes | Condition: New
Both sides fit perfectly and look great!
Verified purchase: Yes | Condition: New