was really easy to install, following the directions. I strongly recommend you buy the recommended coil as well. if you have an older mercruiser with points, be aware that the wire coming from the ignition switch to the coil is a resistor wire and should be replaced for more reliable performance. the new ignition is so strong right out of the box, you will notice the difference immediately.
Verified purchase: Yes | Condition: New
Great fit on my old distributor on my 1977 Atomic 4 sailboat engine. Just make sure the magnet is all the way down on the distributor shaft. It was a tight fit, and I needed to lightly tap it down with a spark plug socket and a small hammer. Of course one should keep the existing plate and points as a backup.
Verified purchase: Yes | Condition: Pre-owned
Easy to install. But you may have to take a small deep well socket and a ball peen hammer to tap the reluctor down to get it to seat fully.
Verified purchase: Yes | Condition: New
Easy to install, very good instructions to follow. Shipping is the only reason it got 4 stars i ordered 3 parts this one being the first part i ordered i received ny other parts a week before this one arrived.
Verified purchase: Yes | Condition: New
My 11 year old grandson installed it for me as my back was bothering me & bending over my boat motor was too much, he did it all in about 15 minutes. and it started right up..
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Engine Sensors & Switches
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
