Picture 1 of 1
![Stock photo](https://i.ebayimg.com/images/g/K30AAOSwaAlckqlI/s-l640.jpg)
![HOLLEY / DEMON / QFT NEW CENTER HUNG NITROPHYL FLOAT - Picture 1 of 1](https://i.ebayimg.com/images/g/djEAAOSw6bVi2dMu/s-l500.jpg)
Picture 1 of 1
![Stock photo](https://i.ebayimg.com/images/g/K30AAOSwaAlckqlI/s-l640.jpg)
![Picture 1 of 1](https://i.ebayimg.com/images/g/djEAAOSw6bVi2dMu/s-l1600.jpg)
I run Holley carbs on several cars, mostly 3910, 750 Holleys .This is the float you need for the rear floatbowl to have adequate clearance, The brass one's are great but will be too long for the rear ,possibly hit the metering plate may cause flooding due to the float not being able to have full travel. This Nitrophil float will not give you this problem and will work in either front or rear.
Verified purchase: Yes | Condition: New
These floats are high quality, very well made. The supplier is first rate and ships so you don’t have to wait. The parts and supplier are anyone’s best choice.
Verified purchase: Yes | Condition: New
I recommend this float. Works much better than my previous plastic float. When I need another,I'll definitely get one of these. I've used brass in the past too,these are better.
Verified purchase: Yes | Condition: New
I orders these correctly after ordering another set of brass floats incorrectly. 4010 Holleys are not as popular as I hoped but we are back up and running. These were installed on a 1992 MasterCraft Prostar 205 with an Indmar 351 Ford Windsor V8. 285 HP with plenty of hole shot. Guess and check method to set float position.
Verified purchase: Yes | Condition: New
Just the float I needed .
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Carburetor Parts