 |
I had to replace the ground clamp after the first use and also the rod holder. The originals fell apart very quickly. So far the unit works fine for stick welding and plasma cutting. I also had to order consumables for cutting because of the rapid deterioriation after a few usage. I have not yet tried Tig welding but hope to soon.
Verified purchase: Yes | Condition: New
need to repair some fencing around my property and this item did it with no problem. i haven’t had a chance to use the plasma cuttjng feature but overall, i’d rate this tool as a decent weekend warrior item =)
Verified purchase: Yes | Condition: New
it does come with a plug but would recommend just removing the power cord and replacing with a 12awg 16ft one easier to use . came with arc cables a little on the short side but will work . the unit has a gas solenoid but no regulator comes with it or tungstens . other than that it came quickly and well packaged .seems perfect for those quick little jobs
Verified purchase: Yes | Condition: New
Received cut60 today hooked it up turns on ,no air leaks holds air, it all works turns on turns off with slight delay cuz the capacitors holding charge but goes off after turning switch off within 30 sec.havent used it all the way is late will cut tomarrow.with all the bad press on problems mine so far has none,,electrical 220 air everything works, will keep u posted after I cut with it however I wouldn't spend more than 230.00 is a small machine. As I said I would use it the next day and report back worked great , so igbttech has done a very good job on delivery answering questions and follow up,, thanku igbttech ,,I'm looking for a pulse mig next, so good to do bussiness with u
Verified purchase: Yes | Condition: Pre-owned
Unit worked very well once I got the hang of setting cutter tip height. You do not have to drag the tip when cutting, just touch off and lift the tip slightly above the work. The ground cable is too short, I made up a longer one. Buy extra consumables, the aftermarket tips are a bit longer and easier to use. I have been cutting 3/16 steel for a project and probably cut a total of 3 to 5ft of material. Unit set at 35 amps, 60lbs air pressure. Ive used 1 tip
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Plasma Cutters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Plasma Cutters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
