 |
This Honeywell control board can be used to replace a large number of older and outdated or obsolete control boards. This is the brain of your HVAC system. You must be careful to connect all the wires to the similar connections on this newer board for everything to work properly. Some of the names printed next to the connections have different names than what you may find on your older board. For example, S is the same as L1, designating the “hot” connection. N is the “neutral” or where many of the white wires will be connected to. The draft inducer motor can be designated as IND, or DI on an older board. Depending on your skill level or experience with HVAC wiring, you may have to spend some time on Google figuring out which connection corresponds properly to your old board. I did not need any additional special adapter wires that some of these new boards come with. If your old board has nine pin connectors instead of this newer one with six pin connectors, you will need those adapters that may or may not be included with your purchase. Be alert and carefully look over your old board to see if those adapter wiring connectors will be needed. If you need them and it does not come with them you have another problem. Finally, mounting this will require a drill and some self tapping sheet metal screws. It is unlikely that the holes from your old mounting will line up with this new one. This board is a good value if you have an obsolete one that needs to be replaced and you cannot find an exact original. There are cross reference tables you can find to be sure this one will work perfectly replacing your old one.Read full review
Verified purchase: Yes | Condition: Pre-owned
This circuit board was just as described. So easy to install. Worked perfect and now my furnace is giving me the heat I need up here in the cold. You sold this for way less than the others New in the box. Even less than some of the used ones. Thank you so much !
Verified purchase: Yes | Condition: New
This is a universal replacement for several Honeywell boards so it's not an exact replacement. However, the instructions are clear with table that shows where each wire goes. It looks complicated but don't panic and follow the table and you'll be good. Also the mounting points are different, you may need a drill to make new holes.
Verified purchase: Yes | Condition: New
Good package, item in good shape and worked fine after installation. Detailed instructions but I found where X and C connectors were too Big for my wires, I had to specially clip them off slightly to fit.
Verified purchase: Yes | Condition: New
My furnace is a Armstrong Ultra V with the ST9160B1068 board. And this thing fits perfectly without any additional plugs. Just got to make sure every wire goes to where it’s suppose to go. I’m not a service tech and I did this myself. Definitely recommend.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in HVAC & Refrigeration: Controls & Circuit Boards
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on HVAC & Refrigeration: Controls & Circuit Boards
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
