CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Soldering Guns & Irons
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Soldering Guns & Irons
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
I watched and read reviews about it before I bought it. Plus its cheap so I didn't expect it to be super good. It took a bit to get used to, but once I did it works pretty great. The handle gets pretty hot especially at the highest setting, so I have to be careful. It's probably the cheapest that you can buy, and it does what its supposed to, so I'm satisfied. As someone else said, a good first hot air rework gun.
Verified purchase: Yes | Condition: New
A great first rework hot air station. Great value, good quality although the plastic edges could use a bit of sanding as they are extremely sharp, and the 3 nozzles included will help you get started. I recommend to practice on some old boards. Out of the box you can be ready in as little as 1 minute, just attach a nozzle, place the handle in the cradle, turn on station and adjust the temperature and fan speed as required. To protect from overheating, do not turn off power until the fan stop. I found 350ºC and half speed for fan works for me, with middle size round nozzle included most used. You may consider buying other nozzles after you gain some experience.
Verified purchase: Yes | Condition: New
temp settings might as well not be there,I had to have it on the highest setting to even get the solder to melt.Had it on 500 degrees and my temperature gun would rean a little over 300 degrees,And yes i let it warm up for a long time.
Verified purchase: Yes | Condition: New
Not any real pro's for this total piece of junk.Mine does not regulate temp properly while it ran for a whole week so got maybe 2hrs then unit died.A big waste of $.Don't let cheap price sway you.This unit is worthless IMO.
Verified purchase: Yes | Condition: New
so far is doing the job it was intented for, the only downside is missing some power for BGA processors . . .i couldnt desolder it after 2 min of blowing on it
Verified purchase: Yes | Condition: New
