This carburetor is a great replacement for 632107A. After I put the carburetor on my snow blower, I tried to start it with full choke. With the old carburetor, you had to start it in full choke and leave it there for a little while or the snow blower would die. With the new carburetor in full choke mode I couldn't get the snow blower to start. I was thinking that I might have not put the carburetor on right, but before I worried about that, I turned the choke to half. The snow blower started up, and just after a couple of seconds, I turned the choke off. You couldn't do that with the old carb, It was really cold blooded. Someone said that the ports were smaller in the new carb. They were the same size as the old one that I took off. Great Product!
Verified purchase: Yes | Condition: New
Bought carb and primer bulb for an old 5.0 HP Tecumseh powered 22" Murray snowblower. Carb/bulb removal pretty straight forward (keep track of linkage hole positions). Threaded new primer hose on piece of 19 gage wire and fed through hole. Installed carb, linkages, fuel hose and primer hose. All were OEM fit. Primer bulb has plastic lugs which need slight compression to fit in mounting holes. If they break because you force them like I did, use a little mastic to secure in position. My snowblower was hard to start and ran poorly prior to install. After, started right up and ran smoothly at all rpm's following normal warm up. About 20% of OEM cost wise.
Verified purchase: Yes | Condition: New
Fit on my snowblower good enough to get it running well. Ports were smaller though, so not sure if I'm losing any power because of it. Fuel line connection was different angle and I had to reroute the line to prevent kinking. Choke will not work with the factory adjuster knob. So look to see if that is the same or not. Probably just going to deal with the choke issue instead of get a different carb, cause it doesn't bother me too much and I can probably make it work with a little bit of fabrication of pieces I have laying around. The fuel cup on the bottome doesn't have the quick fuel drain the factory one had either. Not a huge issue, just not as convenient. For the price, it is a pretty good unit.
Verified purchase: Yes | Condition: New
Bought this for a Snowflte I was working on. The carb had been replaced before, so it no longer had a priming stem. The old carb needed to be rebuilt so for a few extra dollars I got that feature back without the hassle of rebuilding the old carb. I installed it and the snowblower started right up, no issues. Would recommend purchasing.
Verified purchase: Yes | Condition: New
Installing this carburetor put new life in an older snowblower. It runs like new again and is easy to start has plenty of power to blow the snow. Very pleased with the results it only took about an hour to replace and I also had to replace primer hose. Takes minimal tools and skill to complete the task well worth the investment.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Lawn Mower Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Lawn Mower Parts