Condition:
4.74.7 out of 5 stars
26 product ratings

  • 5stars

    18ratings

  • 4stars

    7ratings

  • 3stars

    1rating

  • 2stars

    0rating

  • 1star

    0rating

Would recommend95% agree

Good value95% agree

Good quality95% agree

22 Reviews

by

Decent value. Also fits Yukon/ Tahoe

I bought this for my 2016 Yukon. Rough country said it only fit the Silverado and Sierra and I suspected the Tahoe and Yukon had the same intake.
I was missing the 2 clamps everyone else was. I was surprised to see the air inlet hose fittings were some cheap thin plastic. Would have been easy for RC to use metal quick disconnect fittings to retain the factory hoses. Read full review...

Verified purchase:  Yes | Condition: new | Sold by: roughcountry

by

The hose barbs are cheap plastic that don't fit the hoses tightly.

i would rather of had metal than plastic hose barbs. The barbs are smaller than the hose and I put clamps, not included on to ensure the hoses would not come off. The correct sized hose barbs, make of steel would be a great improvement. Everything fix and installed as per instructions without any modifications or fixing adjustments needed.Read full review...

Verified purchase:  Yes | Condition: new | Sold by: levelingsolutions

by

Very good product.

Thanks. Great product and fairly straight forward installing. only issue was the valve vent tubes where bigger id than the od of the plastic connector in kit. Had to use own small hose clamps to hold in place. Not a huge deal. Make sure you don’t install the intake tube to tight to the throttle body as it will rattle at various speeds. Need to clamp it with a gap in the rubber connector so it can move freely without metal on metal as the motor vibrates .Read full review...

Verified purchase:  Yes | Condition: new | Sold by: neverenoughauto

by

Nice product needs a lil work before install.

Fits well. A little loud. They shorted me 2 small hose clamps (per instructions). I also had to make a home polishing tool with a drill to clean the inside of the tube out because it was filled with overspray and metal shavings. No big deal I stapled some scotch brite pads to a wooden dowel rod and got it cleaned out. I’d say it’s worth the money but it needs a little help before install.Read full review...

Verified purchase:  Yes | Condition: new | Sold by: neverenoughauto

by

good product

the clamps are on the cheaper side and had to buy 2 hose clamps but all in all happy with purchase,, can also hear the intake more than factory, may have given me a little more torque, easier to service than the factory air cleanerRead full review...

Verified purchase:  Yes | Condition: new | Sold by: roughcountry

by

Complete the kit

My only complaint is the same as everyone else's, the kit doesn't come with four smaller hose clamps for the breather tubes other wise i would have gave five stars.

Verified purchase:  Yes | Condition: new | Sold by: roughcountry

by

So far so good.

So far so good. 1 take of gas ran after install, will run a couple more tanks and check average results.

Verified purchase:  Yes | Condition: new | Sold by: roughcountry

by

Product will not fit

Waiting on return mailing slip from Rough Country. To mail product back to them. Item will not fit my truck. They must not been aware of the change GMC made in the manufacturing of my truck. Otherwise the product was just fineRead full review...

Verified purchase:  Yes | Condition: new | Sold by: roughcountry

by

Blemish free scratch n dent

Only blemish I could find was a little overspray inside the tube. A little wire brush cleaned it ip

Verified purchase:  Yes | Condition: pre-owned | Sold by: rcscratchanddent

by

Cold air intake review

Easy install, no problems except they left the hose clamps out.

Verified purchase:  Yes | Condition: new | Sold by: levelingsolutions

Why is this review inappropriate?

Cancel
Displaying 1 - 10 of 22 reviews