- All
- New
- Pre-Owned
5stars
2ratings4stars
1rating3stars
1rating2stars
0rating1star
0rating
Would recommend100% agree
Good value100% agree
Good quality100% agree
4 Reviews
Good finish , lightweight
Manifold did not fit properly, would not bolt down to a new aftermarket exhaust manifold. Checked fit on two old exhaust manifolds same problem, will have to have some machine work to fit properly.
Verified purchase: Yes | Condition: new | Sold by: speedway_motors
precision quality
Excellent quality and comes with all hardware except gaskets, If your using the stock type exhaust manifold you will have to do some grinding in certain areas of the exhaust manifold for proper fit (no big deal) If you are using the split manifolds from 12Bolt tom like I did you will have to do some minor grinding on the inside edges of the outer two ports as well as the exhaust manifolds for proper fit. Again no big deal .Take your time and grind a bit and keep checking. ,it doesn't need much. with the split manifolds you will want to buy the water warming plate kit too from 12bolt Tom to heat the manifold and the Fel-pro intake gasket kit will have the gasket for the plate.No extra to get if your using the stock exhaust manifold. You will have to weld two small square plates on the bottom side of the intake to cover the knock out plugs if your going to run the water kit to avoid leaking. No welding needed if your using the stock manifold with exhaust heating.Read full review...
Verified purchase: No
Offy 3 ace
A little more oxidation than I expected, but should be perfect for my application, polishing has commenced
Verified purchase: Yes | Condition: pre-owned | Sold by: 68rob
3x1 intake for 250 six cylinder in my 66 SWB C10
Good looking intake for my 66 short wide.
Gives my truck that NOSTALGIC look,
Keeping with the old original 6 cylinder.
Great conversation piece at car shows and cruise nights.
Verified purchase: Yes | Condition: new | Sold by: speedway_motors