About
All feedback (87)
- phillips_peregrination (1780)- Feedback left by buyer.More than a year agoVerified purchaseThank you for shopping with us! I hope you enjoy your item and stop by again!
- cntelectronicinc (6043)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- popmotorcycle (4006)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- shopmotomentum (482591)- Feedback left by buyer.More than a year agoVerified purchase░▓▄▀▄ THANKS! RIDE SAFE! �� // MOTOMENTUM TEAM ▀▄▀▓░
- motorshopu77 (4381)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- austoppy (3388)- Feedback left by buyer.More than a year agoVerified purchaseGreat buyer！Thank you for your purchase our products.
Reviews (3)
Sep 05, 2020
VERY IMPRESSED!!
For a “Universal” part - This is about as good as it gets! Needed a spark arrester for my 82 IT-465 which has an aftermarket DG pipe and DG silencer. This is the only choice I know of for a U.S.F.S. approved spark arrester for an old dirt bike like mine.
Included is a short bent pipe that’s expanded on one end, and a triangular support bracket to weld on if needed. Both are “cut to fit” parts and worked really well to make it all go together. I cut the short pipe 1st. It goes between the pipe and the spark arrester. Then I cut & welded the bracket to the short pipe which made for a very solid mount.
It sounds good!! But what really made me happy was how much better it made it run! It made a noticeable improvement!! I wasn’t expecting that... (-:
FMF has a great product here which I am very thankful for!! I highly recommend it.
Thank You!!
Nov 07, 2018
Just What I Needed!!
Rebuilding an 82 IT-465 and these replaced the old original bolts. I compared all of these bolts to the old bolts and all were the right length and they really look nice!!
Very satisfied!! (-:
Don’t forget to used a little anti-seize.
May 03, 2019
Didn’t match what it replaced
This had the right part number on it but seems to be too narrow and isn’t very thick at all. It seals my gas cap sometimes, but more often it would leak as the gasket has room to move.
It’s an old Yamaha IT465, but the lid screws on good and tight and this is the part number the Yamaha manual says to use! And for a simple round rubber gasket - it isn’t all that cheap! )-:
The seller did ship it fast. (-: