coachnxs-2 on eBay

About

Location: United StatesMember since: Apr 19, 2012

Feedback ratings

Last 12 months

Positive3- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (57)

blimpie50 (8330)- Feedback left by buyer.
More than a year ago
Verified purchase
Fast payment. A great Ebay buyer!
rtmerc8 (1737)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
tncrash874 (2130)- Feedback left by buyer.
Past year
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
itswhatyouneed (1038)- Feedback left by buyer.
Past year
Verified purchase
Great Buyer! Quick Payment!! A+++++
geeklove321 (886)- Feedback left by buyer.
Past year
Verified purchase
PERFECT - ▄▀▄▀▄▀▄▀▄▀▄▀█▓▒░T░H░A░N░K░ ░Y░O░U░▒▓█▀▄▀▄▀▄▀▄▀▄▀▄
powercallsirens (8472)- Feedback left by buyer.
More than a year ago
Verified purchase
Great transaction, thank for your business!

See all feedback

Reviews (4)

NOS FORD MERCURY LINCOLN OIL PRESSURE SENDER CONTINENTAL MONTEREY FAIRLANE 1956

May 25, 2021

Glad that parts for my old car are still available from sourc4s that care about restorations.

NOS oil pressure sender bench tested ok; will be a while before I actually install it but I don't expect any problem.

New 1954-62 272 292 312 Ford T-Bird Y Block Spark Plug Wire Set & Bracket Kit

Feb 12, 2020

Most like originals and a good buy

This set of spark plug wires is very well made, already cut to length for original type routing, and properly numbered. Only needed some boot grease to complete the installation. The boots are as the originals, being straight on the cap end and 90 degrees on the plug end. Plug wires are black and the coil wire is brown like originals. Excellent crimps on stranded wire. These are not "resistor" wires which is what I wanted. Might need a high frequency filter for the radio but that's ok with me. Wires also have abrasion sleeves where they come near metal engine parts.

Graphite Blank Block Sheet Plate High Density Fine Grain 3/8" x 2" x 12"

Jun 22, 2021

Much better choice for anodes in the electrolysis process !

I have used the electrolysis process for years to remove rust and paint from parts. The sacrificial anode that I would use was old sheet metal that quickly became coated with debris and had to be cleaned in order to reuse. This was messy and time consuming. These bars of graphite 2" x 12" x 3/8" perform well and eliminate the problem of deteriorating anodes. along with the mess. I learned about them on a you tube video and was glad to have found them and I highly recommend them for use in the electrolysis process.

See all reviews