About
All feedback (505)
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- sneakar (186739)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- alienbid (171244)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- alloutfabrication (5304)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for shopping with All out fabrication!
- gonitrohobbies (662456)- Feedback left by buyer.Past 6 monthsVerified purchase▄▀▄█▓▒░ A pleasure to do business with ░▒▓█▀▄▀▄
- rcmart (358839)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
Reviews (4)
Oct 06, 2020
Also works on Mk3 Supra
1 of 1 found this helpful It says for a 4Runner land cruiser or pickup but I i stalled it on my 1989 Toyota Supra 7m-gte and it worked perfectly!
Mar 26, 2018
14 pc ball bearings for xmods.
These ball bearings remove most of the slack in the knuckles and axles on the xmods and they roll a lot smoother and faster I highly recommend these
May 11, 2020
Easy install, might need to bend slightly to fit.
I bought this replacement for the factory hose that went out on me. The only issue I had was that when it is mounted to the rear of the a/c compressor the tubing doesn’t quite clear the air intake boot below the throttle body so I just bent it a little to clear all the other parts and it fits fine, also had to bent the other side to clear the oil dipstick tube as well. Oh yeah this updated hose in no longer ran behind the intake manifold so it comes forward and goes underneath the intake boot by the water filler neck on the engine block. Easy install.