johhaske on eBay

About

Location: United StatesMember since: Nov 02, 2014

Feedback ratings

Last 12 months

Positive4- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (64)

vintageautoliterature (238566)- Feedback left by buyer.
More than a year ago
Verified purchase
PERFECT TRANSACTION IN EVERY WAY THANKS AGAIN FOR BEING A CUSTOMER
*****- Feedback left by buyer.
Past year
Verified purchase
Thank you for shopping with FellowSeller! Great Buyer!
joshoo_4202 (1552)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
*****- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
365daysdeal (43073)- Feedback left by buyer.
Past year
Verified purchase
Hope to deal with you again. Thank you.
midwestmusclecarspecialties (72386)- Feedback left by buyer.
More than a year ago
Verified purchase
Excellent Buyer Thank you for your purchase from Midwest Muscle Car Specialties

See all feedback

Reviews (6)

Untested P&G Valve Gapper Model 300 Basic Unit 300-BU Used Documents Manual Box

Apr 28, 2025

Was repairable.

Oh it was alright being it was not a workable unit. I have the ability to restore things. It's already torn down & cleaned. looking like jewelry now. I will most likely need to make adaptors to fit modern applications. I used one of these in the 60's and wanted to own another. The original had a cable addition which I think was just a brake. Mot really nessecary though.

Bison Lathe Chuck Hard Top Jaw for Scroll 5 in 6-Jaw 6 Piece Set 7-883-605

Jun 09, 2020

Exact fit

Way to expensive.

KD Rocker arm stud remover/ installer 3019

Jul 04, 2018

Way better buy than you know.

I replaced my BHJ puller due to the threads on the shaft being deformed from years of use. A new shaft was $80. plus freight. So this was a real good deal. I checked the hardness on a tester & found the shaft was really tough. The female half was just mild steel. So, I added extreme pressure grease to the threads to give it a fighting chance from fast wear. Knowing tooling a bit, I feel this will do 4 to 6 sets of heads due to the soft female half. On the BHJ, both pieces are hard & that's why they are so expensive. I use a 1/2" drill motor to pull them out so, it gets a little warm & it will wear faster for sure. If you do this by hand, it will last longer I believe, but I have to get things done more quickly than the average. Buy it. It works fine.

See all reviews