mtomal on eBay

About

Location: United StatesMember since: Feb 03, 2002

Feedback ratings

Last 12 months

Positive11- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (719)

efesales (42517)- Feedback left by buyer.
Past month
Verified purchase
(¯`'•.¸(¯`'•.¸(¯`'•SUPER STAR eBayer•'´¯)¸.•'´¯)¸.•'´¯)
watchmt (3080)- Feedback left by buyer.
Past month
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
climbup6939 (1747)- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
*****- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
4bettergoodsllc (143)- Feedback left by buyer.
Past 6 months
Verified purchase
Great customer,easy,fast and simple transaction
goodwillbks (812074)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (12)

Paiste PST7 18" Thin Crash

Sep 21, 2021

Great sounding cymbal

Great sound.

Epiphone SG Special Electric Guitar Has Had Neck Work

May 27, 2020

Grerat SG guitar plays nice

Excellent condition with great custom shop look.

Aluminum Head Spark Plug Hole Rethreading Repair Kit For Ford 5.4L Triton

Nov 27, 2018

A lifesaver for spark plug hole repair

Excellent high quality kit. Perfect for my 2005 Mercury Sable. Being overly cautious I used a Dremel to put a notch in the drive end of the tap & used a slightly longer set screw so when using the extension even if the set screw came loose the notch would hold the tap so it would not drop out of the extension. Use grease on tap & clean tap every few turns. Clean finished new threads well with lacquer thinner to remove grease residue & blow out with air compressor. Use Loctite 271 on bottom half of thread of insert, & JB Weld on top half of thread of insert, and let Loctite set for 15 minutes before removing insert install tool. Use flange tool to make taper seat for plug. Then let sit for at least 24 hours so JB Weld can fully cure and you have a permanent repair.

See all reviews