About
All feedback (49)
- silver-manatee (12868)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- feixiang866 (270)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- tabbay (909)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- psc_recycles (5685)- Feedback left by buyer.Past 6 monthsVerified purchaseA++ customer, WHEN YOU NEED STEEL looking forward to working with you again!!!
- brrepairs (1033)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- megamartonline-700 (5201)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, hope to deal with you again!
Reviews (2)
Aug 24, 2017
Great power supply
Only have 4 hrs on it, not noisy or no interference with other ham equipment.
My buddy that has always used the large non switched power supplies; was impressed and wanted to plan on replacing his saving space etc.
Feb 12, 2019
It worked for me after a little bit of revision.
3 of 3 found this helpful My older 550b frame has the over cut in the bed area. So the support roller would not contact the primer slide. I considered the brass shim but after experiencing difficulty holding the bearing assembly in the slot while manipulating the parts, decided to deepen the slot and just allow the PSBTP lay against frame. SUGGESTION WIDEN PSBTP AND HAVE AN ELOGATED HOLE TO CAPTURE THE BEARING ASSEMBLY. I dropped the bearing assembly several times, etc. it’s just difficult to manipulate the parts. Its fine but complicates the set ups
I recommend this accessory after you tried replacing the control rod and setting up per Dillon. And still didn’t get satisfactory primer drop.