About
All feedback (1,270)
- 5***4 (599)- Feedback left by buyer.Past monthVerified purchaseI tried to contact the seller on three separate messages and I did not receive any response. None of the items were ever sent out to me - if I were a smart ebay buyer I would not purchase any items from this seller! Ebay did give me a complete refund, so the end of this transaction ended up with a good result!
- c***. (191)- Feedback left by buyer.More than a year agoVerified purchaseReceived as advertised; packaged very well; satisfied with purchase.
- 1***7 (109)- Feedback left by buyer.More than a year agoVerified purchaseThe item I ordered is exactly as discribed, arrived ahead of schedule
- h***e (208)- Feedback left by buyer.More than a year agoVerified purchasejust like he said, arrived on time, thanks so much
- o***o (2304)- Feedback left by buyer.More than a year agoVerified purchaseFast shipping and good deal. Thanks.
- l***l (1664)- Feedback left by buyer.More than a year agoVerified purchaseProduct was as advertised A+
Reviews (4)
Mar 15, 2016
Good value manual air pump
Everything worked as listed. The only issue was the nozzle which hooks up to the tire vale was a bit tight so when you released the nozzle it was slow in coming off so some of the air leaked out. A little oil and pumping a few extra pumps before diconnecting the nozzle solved the problem.
Aug 01, 2017
Output wires for bullet connector.
1 of 1 found this helpful A good power source for RC chargers requiring high amps. If you plan to constantly draw 40 amps or use mutiple high output chargers be sure you use at least 12 gauge wiring anything smaller and the wire can get hot. I am running 3 high out put chargers and use 10 gauge wire from the power supply to the three way spliter after that I use 12 gauge wire to the chargers. Fan is constantly on which I like because I charge large 6S lipos and I've seen a few thermostat failures which can cause the power supply to burn up.
May 21, 2016
Instuctions for use needs some updating
9 of 9 found this helpful Mixing instructions are good. Application of cement to the crown and base of the tooth needs to dry. User needs to have something to bite down on to force the crown in place (a small paper towel rolled up to about the size of a cigarette), wait a few minutes for cement to set. Finally gently use a floss and pick to clean out excess cement. .