About
All feedback (1,916)
- l***7 (613)- Feedback left by buyer.Past yearVerified purchaseShipped fast, thanks
- t***a (1)- Feedback left by buyer.More than a year agoVerified purchaseThere was a delay by the Post Office, I do not blame the seller. Overall, it was a good transaction. The box the watch is in was a little beat up but the unit should be fine. I am giving this as a gift.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- m***r (1614)- Feedback left by buyer.More than a year agoVerified purchaseSMOOTH TRANSACTION AAA
- o***d (829)- Feedback left by buyer.More than a year agoVerified purchaseReceived in very good condition. Returning due to my mistake!!!
- mscindustrialsupplyco (35018)- Feedback left by buyer.More than a year agoVerified purchaseA pleasure to do business with this buyer.
Reviews (5)
Sep 21, 2022
Unusable due to weak Screw
The Mandrel and Washers are good quality. Where this item fails is in the Screw that holds on the cut off wheel. A small amount of pressure against the cut off wheel and the screw will shear of in a few seconds leaving the broken screw shaft inside the Mandrel making the mandrel useless. I used a screw from another similar Mandrel I had and the Mandrel worked fine and the screw did not Shear off. I now have 7 of these with screw heads that sheared off leaving the mandrels unusable.. I cannot use the others or the same thing will happen. I bought these so I could have a variety of cut off wheels and sanding discs available to go right on the Dremel without have to change the disc each time..
Dec 26, 2019
Great Unit
3 of 3 found this helpful I have put about 6 Hours of use on it, since I got it. It works incredibly well.
It doe take some time to heat up, but most units that are affordable do also.
It gets very hot. I am using it on Auto parts, mostly carburetors.
For the price you cannot beat this unit.
Sep 13, 2019
Do Not Buy for Cam-Am 400 Outlander
0 of 1 found this helpful Do not buy this for the Can-Am Outlander 400. This is only a 2 position switch ON/OFF. While this will plug into the harness your headlights will be on all the time.. This does not replace the 3 position Can Am 400 switch part number.