About
All feedback (55)
- nunu55_12 (616)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- stm_surplus (51829)- Feedback left by buyer.Past yearVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- buonshopping (217124)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction.Excellent buyer. A++++++.
- tsunamimopper (11719)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- j2depot (4431)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- metromusic1 (9629)- Feedback left by buyer.More than a year agoVerified purchaseGreat Buyer! Fast Payment! A++ Please Leave All 5-Stars Positive Feedback
Reviews (2)
Jul 13, 2016
Good generator but a little under powered
6 of 10 found this helpful Purchased for construction after another generator was stolen from a job site. My other generator was a 5k peak watt model and had no problem powering multiple machines but this one bogs down a little running just a single miter saw so I have to be careful how much load I put on it but with a little care and planning I can work around it.
Jan 30, 2019
Good machine for the money!
2 of 2 found this helpful Only been using it for a week but for what this laser costs it seems to be a good value. Did take some trial and error getting the tube installed and not burning out the HV connection. Also getting all the mirrors and lens adjusted took a little while but there is an excellent YouTube video that walks through the process. I would recommend doing a bit of interweb searches to help you though the setup as the Chinese manual and videos are of much use. Lightburn is worth the cost and works well with the Ruida DSP controller this unit comes with. Buy a chiller (~$100 on eBay) and don't even mess with the aquarium pump this comes with. After doing some test cuts comparing it to the same image I cut on a friends BossLaser I'm glad I saved the $6k-$7k by getting this laser. Even if I have to replace the tube in 2000 hours it's still a bargain and now that I set up the laser and mirrors once it will be much easier. Need to look into adding the motors for the z axis as this unity in manual in that axis.